1966 A&BC Batman Black Bat #37 — Raw

Centering estimate: left border ~8mm, right border ~5mm, top border ~5mm, bottom border ~4mm — roughly 60/40 L/R and 55/45 T/B, which is acceptable for vintage A&BC stock but the left-heavy lean is notable. Corners show visible rounding on at least two corners (bottom-left and top-left appear soft in the image), consistent with a VG-EX range. Surface shows toning and general age wear with some gloss loss typical of 57-year-old British card stock; no obvious hard creases are visible from this photo but the image resolution is not sufficient to rule out a light surface crease. Edges appear slightly rough but this is normal for A&BC cuts and should not be over-penalized; overall condition points to a 4 VG-EX as the most likely grade, with 3 possible if corner rounding or hidden surface wear is worse than it appears.

Centering estimate: left border ~35%, right border ~65% left-to-right, top border ~40%, bottom ~60% top-to-bottom — off-center but not miscut territory. Corners show visible rounding on at least three corners, most notably the bottom-left and top-right, consistent with VG range. Surface shows moderate gloss loss across the face and there appears to be light toning/wear on the borders typical of A&BC stock aging. No obvious hard creases are visible from this photo angle, but the sleeve glare and image quality prevent confident exclusion of surface creases — a back-side examination and corner close-ups are needed before committing to the upper end of this range.

Centering estimate: left border ~8mm, right border ~4mm, top border ~5mm, bottom border ~6mm — left/right ratio approximately 65/35 to 70/30, top/bottom roughly 45/55; centering is noticeably off horizontally. Corners show visible rounding on all four, most evident at top-left and bottom-left, consistent with a VG to VG-EX range. Surface shows general gloss loss and toning consistent with age; the pink/red background makes print defects harder to assess but no obvious heavy creases are visible from this photo, though light surface wear appears present. Edges appear reasonably intact with some roughness typical of A&BC cuts; the combination of rounded corners, gloss loss, and off-centering places this most likely in the PSA 3 VG range, with the back unseen and corner closeups unavailable widening uncertainty to 2–4.

Centering estimate: left border appears noticeably wider than right (~65/35 L/R), top border slightly wider than bottom (~55/45 T/B) — off-center left-to-right is the primary centering concern. All four corners show visible rounding and wear, consistent with heavy handling; no corner is sharp. Surface exhibits significant toning and dirtying across the face, with apparent gloss loss particularly in the lower half; there is possible light creasing visible in the upper-left quadrant though the photo resolution makes confirmation uncertain. Edges appear roughly cut as expected for A&BC stock but show additional wear fraying. The combination of rounded corners, surface wear/toning, and possible crease places this firmly in the VG (3) range, with a floor of 2 if the suspected crease is confirmed on inspection and a ceiling of 4 VG-EX only if surface and corner wear is lighter than it appears in this photo.