1966 OPC Batman Black Bat #45 Trap for the Riddler

Centering: left border appears slightly wider than right (~55/45 L/R), top border appears slightly wider than bottom (~55/45 T/B) — centering is respectable and not a major deduction. Corners: at this image resolution all four corners appear reasonably sharp with only very light rounding evident, consistent with EX-MT to NM range; no corner is blunted enough to suggest heavy use. Edges: the cut appears typical for OPC vintage stock — slightly rough but no major nicks or tears visible. Surface: overall gloss appears present with no obvious creases; some minor print texture/grain is visible but consistent with normal 1966 OPC stock rather than damage — no staining or writing detected. The seller's NRMT claim is plausible but slightly optimistic; without corner macro shots and back inspection, a range of EX to NM (5–7) is appropriate, with EX-MT (6) as the most defensible single estimate.

Centering estimate: left border appears slightly wider than right (~55-60% left), top border slightly wider than bottom (~55% top) — overall moderate left/top lean, roughly 60/40 both axes, which is acceptable for mid-grade. Corners show visible light rounding on at least two corners (lower-left and upper-right most visible), suggesting EX to VG-EX range rather than NM. Surface shows some gloss loss consistent with handling but no obvious creases are visible in this photo; print quality appears typical for OPC with slight color saturation variation. Edges appear reasonably clean with no major nicks visible, though the rough-cut nature normal for OPC/vintage stock makes full edge assessment difficult from this single front-only image — back condition and corner closeups are unavailable, widening the range.

Centering estimate: left border appears narrower than right (roughly 60/40 L-R favoring right side), top border slightly larger than bottom (roughly 55/45 T-B) — centering is off but not severely so, no miscut detected. Corners show light-to-moderate rounding on at least two visible corners (lower left and lower right appear softer), consistent with EX to VG-EX range. Surface shows some gloss loss and possible light toning/aging typical of OPC issues; no creases are apparent from this view but the back is unexamined. Edges appear reasonably intact with no major tears or chips, though some roughness consistent with normal vintage OPC cutting is present — this is not penalized per vintage standards.

Centering estimate: left border ~6mm, right border ~4mm, top border ~5mm, bottom border ~4mm — approximately 60/40 L/R and 55/45 T/B, which is acceptable but not tight. Corners show light-to-moderate rounding on at least the visible bottom-left corner; top corners appear slightly better but show some wear consistent with handling. Edges appear reasonably clean with no obvious nicks visible at this resolution, consistent with normal OPC rough-cut stock. Surface shows decent gloss retention with no visible creases, though the image resolution limits crease detection with certainty; a back inspection would be needed to confirm. Overall the card presents as a solid EX (5) candidate, with the corner condition being the primary limiting factor — clean surfaces could push to EX-MT (6) but corner rounding likely keeps it at the lower end of the range.