1966 OPC Batman Red Bat #6A Facing the Axe — Raw

Centering estimate: left border noticeably wider than right (~65/35 L/R); top border slightly wider than bottom (~55/45 T/B) — off-center left-to-right is the primary concern. All four corners show visible rounding and wear, particularly the top-right and bottom-right which appear the most stressed. Edges show roughness consistent with the OPC coarser cut (not penalized per vintage norms) but also signs of handling wear. Surface has visible creasing or stress lines especially in the lower-center/lower-left region near the bat logo, with some gloss loss evident; no obvious staining or writing detected. The combination of rounded corners, apparent surface crease, noticeable off-centering, and gloss loss places this firmly in the VG (3) range, with VG-EX (4) possible if the surface stress lines are lighter than they appear and the crease is minimal, and GOOD (2) possible if the crease is heavier upon physical inspection.

Centering estimate: left border appears narrower than right (~60-65% right-heavy), top border slightly narrower than bottom — approximate L/R ratio roughly 60/40 to 65/35 and T/B roughly 55/45, putting centering in the EX to NM-MT range on that axis alone. Corners show visible light rounding on all four, most notably the upper-left and lower-left corners, consistent with a PSA 4-5 grade. No creases are visible in the image, gloss appears partially present but with moderate loss across the surface. Edges appear reasonably clean with no major nicks visible, which is typical for OPC stock; no adjacent card printing is visible so no miscut concern. The back is not visible, limiting confidence — back print defects, staining, or hidden creases could push this lower toward a 4.

Centering: left border appears narrower than right (roughly 60/40 L-R favoring right), top border slightly wider than bottom (approximately 55/45 T-B) — centering is off but not severely so. Corners: all four show some rounding and softening visible at this resolution; no corner is sharp, suggesting wear consistent with EX to VG-EX range. Edges: appear reasonably clean with no obvious nicks or tears visible, consistent with the rougher OPC cut stock which should not be over-penalized. Surface: gloss appears moderate with some light loss; no creases are visible in the image, though the scan angle could obscure light surface creases — no staining or writing noted. Overall impression is a solid EX (5) card with the range extending to VG-EX (4) if hidden surface wear or crease exists on the back, and EX-MT (6) as a ceiling if corners are better than they appear at scan resolution.