1977 OPC Star Wars #123 Solo blasts a stormtrooper!

Centering estimate: left border appears noticeably wider than right (~65/35 L/R), top border slightly wider than bottom (~55/45 T/B) — centering is off but not severely miscut. The red border shows some chipping or wear along the left and bottom edges visible at this resolution. Corners appear to have light to moderate rounding, particularly on the lower-left and lower-right, consistent with EX to VG-EX range. Surface gloss appears present but slightly dulled; no obvious creases visible from this angle, though the photo does not allow close corner inspection. Back is unseen, and corner detail is limited by image resolution, so the range is widened accordingly.

Centering estimate: left/right borders appear approximately 60/40 favoring left, top/bottom approximately 55/45 favoring top — acceptable for a 7 but not crisp enough to rule out worse. The red border shows no obvious chipping or major wear, but the photo resolution limits fine corner assessment; corners appear to have light rounding consistent with EX-MT to NM range, with no sharp razor points visible. Surface gloss appears intact with no obvious creases or staining evident in the image. The bilingual caption ('Solo élimine un soldat d'assaut!') confirms OPC Canadian issue, consistent with the listing; back cannot be assessed from this photo, and corner condition is the main uncertainty capping this estimate.

Centering: left border appears slightly wider than right (~55/45 L/R), top border noticeably thinner than bottom (~60/40 T/B) — centering is passable but not tight. Corners: upper-left shows visible wear/rounding; the remaining three corners appear moderately soft with slight rounding — no corner is sharp enough for NM or better. Edges: minor roughness consistent with OPC's coarser cut, no obvious nicks or major chips visible. Surface: the photo image shows some gloss loss and what appears to be light handling wear across the surface; no creases are visible, and no staining is apparent, though the single front photo limits assessment of print defects on the reverse. Overall this presents as a solid EX (5) candidate, with EX-MT (6) possible if corners and surface hold up better under direct examination.