1977 OPC Star Wars Stickers #36 Star pilot Luke Skywalker!

Centering estimate: left border appears slightly wider than right (~55/45 L/R), top border slightly wider than bottom (~60/40 T/B) — acceptable for this issue. Corners appear intact with minimal rounding visible at this resolution; no obvious blunting but fine corner tips are difficult to confirm definitively. The red filmstrip border shows no obvious chipping or edge wear, and surface gloss appears largely intact with no visible creases or staining. The image quality limits close inspection of corner crispness and potential light surface wear, warranting a widened range; this looks like a solid EX-MT to NM card pending any hidden back-side or corner flaws.

Centering: left/right borders appear approximately 60/40 and top/bottom roughly 55/45 — acceptable for the grade range. Corners appear lightly softened but not severely rounded; at card-size inspection two corners show minor blunting consistent with EX-MT to NM range. Surface gloss looks reasonably intact with no obvious creases or staining visible in this photo, though the scan angle and slight warmth in tone make it difficult to rule out light surface wear or minor print artifacts. The die-cut filmstrip border edges appear intact with no major chips or tears, though fine edge condition cannot be fully assessed without a sharper macro image; range widened accordingly.

Centering: left/right borders appear roughly 55/45 favoriting left, top/bottom approximately 60/40 favoring top — acceptable for the grade range. The red filmstrip border shows some toning and the card surface has an aged, slightly flat appearance suggesting moderate gloss loss consistent with EX to VG-EX range. Corner detail is difficult to fully assess at this resolution but at least two corners (bottom left, bottom right) show what appears to be light rounding or softening. No visible creases are apparent from this angle, and no staining or major surface defects are detected. The overall presentation supports an EX (5) grade as the most likely outcome, with EX-MT (6) possible if corners prove sharper than they appear, and VG-EX (4) if light corner rounding is confirmed on inspection.