1977 Topps Star Wars #129 "May The Force be with you!" — Raw

Centering estimate: left border appears narrower than right (~55-60% right-heavy), top border slightly wider than bottom — approximate L/R ~40/60, T/B ~55/45, suggesting moderate off-center but within EX-MT range. Corners appear lightly worn with possible very slight rounding visible at all four corners, most pronounced at upper right, consistent with a 6 grade. Surface gloss appears present but slightly reduced; no creases are discernible in this image, and the red border shows no obvious chipping though the scan makes fine edge wear hard to confirm. The image quality is good enough for a general assessment but corner and edge detail at full resolution would be needed to tighten the range; a grade of 5 is possible if corner rounding is more significant than it appears.

Centering: left border appears slightly narrower than right (~55/45 L/R), top border modestly wider than bottom (~55/45 T/B) — centering is acceptable for a PSA 7 or 6 range. Corners: all four corners show light wear with what appears to be minor blunting, most visible at the lower corners; no sharp points evident but no severe rounding either — consistent with EX-MT (6) to NM (7) range. Surface: gloss appears reasonably intact with no obvious creases, staining, or print defects visible; the red border shows no significant chipping. Edge quality looks clean from this angle. The single-image limitation prevents inspection of back condition, corner closeups, and fine surface scratches, warranting a widened range; seller's EX-MT claim aligns with the visible evidence.

Centering: left red border appears roughly 10–12% wider than right, top border slightly wider than bottom — estimating approximately 60/40 L/R and 58/42 T/B, within NM-MT range on that axis alone. Corners appear reasonably sharp with minimal rounding visible at this resolution; no obvious corner wear under casual inspection, though the scan does not allow tight corner closeups. Surface gloss appears present with no visible creases, staining, or print defects; the photo image is clean. The red border on this series is prone to chipping on edges — edges look intact but cannot be fully confirmed from this single overhead photo, which is why the range is widened to 6–8; a soft corner or edge chip hiding in the scan could drop this to EX-MT or below.