1977 Topps Star Wars Stickers #3 Han Solo — TAG (grade unconfirmed)

Centering: left/right borders appear approximately 60/40 favoring left, top/bottom roughly 55/45 — acceptable for the grade range. The green die-cut border shows no obvious chipping or significant edge wear visible at this resolution. Corners appear to have light rounding on at least the lower corners, consistent with EX-MT to NM range — no razor-sharp corners are evident but no dramatic rounding either. Surface gloss appears reasonably intact with no obvious creases or major print defects visible; however, the back cannot be assessed and sticker backs (peel condition) are relevant to PSA's evaluation. The die-cut edges look clean without major tears or fraying, which is the critical vulnerability on stickers of this vintage.

Centering estimate: the green die-cut border appears left-heavy with slightly more black bleed on the right side — approximate L/R ratio ~60/40, T/B roughly 55/45, which is within acceptable range. Corners are difficult to assess precisely through the case plastic and glare, but no obvious severe rounding or creasing is visible; corners appear to have at most light wear consistent with an EX-MT range card. Surface gloss looks reasonably intact through the plastic with no obvious creases or major print defects visible, though the case glare obscures fine surface detail. The sticker shows no evident chipping of the green border, and the yellow caption banner reads cleanly; a closer corner and edge inspection without the case would be needed to confidently separate a 6 from a 7.

Centering estimate: left border appears slightly wider than right (~55/45 L/R), top border marginally wider than bottom (~55/45 T/B) — centering is within NM-MT tolerance. The green die-cut border shows no obvious chipping or fraying along the edges visible in this photo. Corners cannot be assessed with high precision from this angle and distance, but the upper-left and upper-right corners appear to show very slight softening consistent with light handling; lower corners are harder to read. Surface gloss looks intact with no visible creases, staining, or print defects, though the photo angle does not reveal fine scratches or sticker-back condition. The range of 6–8 reflects uncertainty about corner wear and edge condition on the die-cut perimeter that a closer inspection would resolve.