1977 Topps Star Wars Stickers #32 Preparing for the raid! — Raw

Centering estimate: left border appears slightly wider than right (~55/45 L/R), top border noticeably wider than bottom (~60/40 T/B) — centering is off but not severely so. The filmstrip die-cut edges show some roughness consistent with normal production cutting for this sticker issue; white border shows mild toning/yellowing around the perimeter. Corners appear lightly to moderately rounded — at least two corners (lower-left and lower-right) show visible wear suggesting EX to VG-EX range. Surface gloss is reduced and the image appears slightly soft, consistent with age and handling; no obvious creases are visible from this photo but the scan angle and resolution make a definitive surface call difficult. Overall condition reads mid-grade, most likely PSA 5 (EX), with the range spanning 4–6 depending on what reverse and corner closeups would reveal.

Centering estimate: left border appears slightly wider than right (~55/45 L/R), top border noticeably wider than bottom (~65/35 T/B), so centering is passable but not tight. Most damaging issue is a visible crease or fold line in the upper-right area of the card — the card surface shows a clear diagonal stress mark/crease near the top-right corner, which is a grade-limiting defect. Corners appear softly rounded rather than sharp, consistent with light-to-moderate handling wear. Surface gloss appears partially intact but the crease and general wear push this toward the VG-EX to EX range. The COA watermark partially obscures the lower image area, limiting full surface assessment.

Centering estimate: the film-strip border appears slightly wider on the left than the right (approx 60/40 L/R) and slightly heavier on the top than bottom (approx 60/40 T/B) — acceptable for NM-MT range. Corners: all four appear relatively sharp at this resolution; no obvious rounding or blunting is visible, but the photo is not a macro shot so fine corner wear cannot be ruled out. Surface and gloss: the image surface looks clean with good reflectivity and no visible creases, scratches, or print defects; the sticker die-cut edges appear intact and reasonably clean. Primary uncertainty is corner condition under magnification and the back/adhesive condition, which cannot be assessed from this single front photo — these factors could push the grade toward the lower end of the range.

Centering estimate: left border appears slightly wider than right (~55/45 L/R), top border slightly wider than bottom (~55/45 T/B) — centering is acceptable and not a significant grade detractor. The black film-strip border shows light chipping/wear along edges, consistent with typical handling for this issue. Corners appear to have mild rounding on at least two corners (most visible at bottom-left and top-right), consistent with EX to EX-MT range. Surface gloss appears modestly retained but shows some dulling; no creases are visibly evident, though the resolution limits certainty. The card reads as a solid mid-grade raw example, most likely PSA 5 EX, with EX-MT (6) possible if corners are sharper than they appear in this photo.

Centering estimate: left border appears slightly wider than right (~55/45 L/R), top border noticeably wider than bottom (~60/40 T/B) — centering is acceptable but not tight. The film-strip die-cut edges appear reasonably clean with no obvious chipping or major roughness visible along the perimeter. Corners are difficult to assess precisely at this resolution but show no obvious rounding or blunting at any of the four points, suggesting at least EX-MT condition. Surface gloss appears intact with no visible creases, staining, or print defects; the image is clean and well-centered for a sticker issue. Cannot confirm back condition, corner sharpness under close inspection, or minor edge wear from this single front photo, so the range is widened accordingly.