1977 Topps Star Wars #75 Darth Vader strangles a rebel! — Raw

Centering: left red border appears noticeably wider than the right (~60-65% left / 35-40% right), and top border appears slightly wider than bottom (~55/45 T/B) — off-center left/right but not severely so, consistent with EX-EX-MT range. The top-left corner shows visible wear and what appears to be a small ding or crease beginning, and there is a noticeable surface scuff or wear mark visible in the upper-left corner area of the card; the other three corners appear to have light rounding consistent with handling. The red border shows no dramatic chipping but the upper-left corner wear is the key grade-limiting flaw. Surface gloss appears moderate — present but not full, suggesting some handling loss. Back cannot be assessed; no creases are visible on the face but the upper-left corner damage and centering pull the grade toward EX (5), with EX-MT (6) possible if the corner damage is less severe than it appears at this resolution.

Centering estimate: left/right borders appear approximately 70/30 favoring the left, top/bottom roughly 60/40 — off-center but not severely so. The red border shows visible chipping and wear consistent with this series; corner wear is apparent on at least two corners (lower-left and lower-right show rounding), and the upper corners appear slightly better but still soft. The card exhibits some surface wear and gloss loss across the face, and the lower-left corner of the card body shows what appears to be a fold or soft crease near the starburst logo area. No hard creases are clearly visible in the photo but the worn corners and border chipping, combined with moderate gloss loss, place this squarely in the VG-EX to EX range; back condition is unknown and could push the grade down.

Centering estimate: left border appears slightly narrower than right (roughly 55/45 L/R), top border slightly narrower than bottom (roughly 60/40 T/B) — within NM-MT range horizontally but the perspective distortion reduces confidence. Red borders on this series chip and wear at corners; under the photo resolution all four corners appear reasonably intact with no obvious rounding or chipping visible, suggesting at least EX-MT condition. Surface gloss appears present but the photo angle and ambient light make it difficult to rule out minor wear or print defects. Edges look clean with no visible fraying. Given the photo limitations — no corner close-ups, slight perspective distortion — a range of PSA 5–7 is honest, with EX-MT (6) as the most likely grade pending back inspection and corner examination under magnification.