1977 Topps Star Wars Stickers #1 Luke Skywalker

Centering estimate: left green border appears slightly wider than right (~55/45 L/R), top border slightly wider than bottom (~55/45 T/B) — acceptable for the sticker format. The die-cut green border shows no obvious nicks or tears visible at this resolution. The photo/image area appears clean with good color saturation and no visible print defects or staining. Corners on the green die-cut border are difficult to assess precisely due to case glare and the shaped die-cut edge, but no rounding or fraying is apparent; surface gloss looks intact. The snap case obscures edge and corner detail, widening the range — a closer or unobstructed image would tighten the estimate considerably. Collector note: the two-asterisk copyright line (••) is the O-Pee-Chee Canadian sticker tell, but this distinction lives in fine print and cannot be confirmed definitively without back inspection.

Centering estimate: the green die-cut border appears roughly even left-to-right (approximately 50/50) and slightly tighter at the top than the bottom (approximately 55/45 T/B) — centering looks acceptable for NM range. The die-cut edges appear clean and intact with no visible nicks or tears along the sticker border shape. Corner assessment is limited by the hard case and angle, but no obvious rounding or fraying is visible on the corners of the sticker itself. Surface gloss appears strong with good color saturation and no visible creases, staining, or print defects discernible through the case; however, the plastic housing and mild glare prevent confident assessment of fine surface wear or the sticker's adhesive layer condition, which is a critical factor for sticker grading. Grade range reflects this uncertainty — a clean NM-7 to NM-MT-8 is most likely, with EX-MT-6 as a floor if hidden edge or surface issues exist.

Centering on the backing card reads approximately 55/45 left-to-right and 52/48 top-to-bottom — quite good for this notoriously off-center issue. The die-cut sticker itself sits evenly within the black backing. Corners on the backing card appear reasonably sharp with only very light wear visible at the lower-right and upper-left, consistent with a 7–8 range. Surface gloss looks intact with no obvious creases, print defects, or staining visible; the green border shows no evident chipping. The photo does not allow close inspection of the die-cut edge quality or the card back, and corner micro-wear is difficult to confirm at this resolution, so the range is intentionally widened; a PSA 8 is achievable if corners are cleaner than they appear, while a PSA 6 is the floor if hidden edge or corner wear is present.

Centering estimate: left border appears slightly wider than right (~55/45 L/R), top border noticeably wider than bottom (~65/35 T/B), so centering is acceptable but not tight. Blue borders show visible chipping and wear along all four edges, which is characteristic of this issue but here is pronounced enough to cost grade. Corners: all four show rounding, most notably the bottom-left and top-right, consistent with a VG-EX (4) to EX (5) range. Surface gloss appears partially intact with some dulling visible on the image area; no creases are evident from this angle but the photo angle and lighting obscure the lower-left corner and edges fully, preventing a confident read on whether a crease is present. Given the corner rounding, edge chipping on the blue border, and moderate surface wear, a PSA 4 (VG-EX) is the most likely outcome, with 5 possible if corners are slightly better than they appear and no hidden creases exist.