1977 Topps Star Wars Stickers #7 Lord Darth Vader

Centering on the card stock (black background): left border ~15%, right border ~15%, top ~20%, bottom ~20% — appears reasonably well centered, approximately 55/45 L/R and 55/45 T/B. The die-cut sticker itself sits slightly left of center on the card backing but that is typical for this issue and not penalized. Corners of the card appear to have light-to-moderate wear with slight softening visible especially at the lower-left and upper-right; no sharp razor corners evident but no heavy rounding either, consistent with NM range. Surface gloss appears intact with no obvious creases, scratches, or print defects visible at this resolution; the image reproduction is crisp and colors are vibrant. The card stand and angle slightly obscure the bottom corners and edges, preventing a definitive corner and edge assessment — back condition unknown.

Centering on the card stock (not the die-cut sticker itself): left/right borders appear roughly 55/45 and top/bottom roughly 60/40 — acceptable for this issue. The die-cut sticker appears well-centered within the card backing. Corner assessment is hampered by sleeve glare, but upper-left and lower-right corners show visible rounding under the plastic, consistent with a 5–6 range; no sharp needle points are evident. Surface gloss appears partially intact but the photo reveals what looks like light surface wear or scuffing in the mid-section — the glare makes a definitive call impossible. No creases are visible, but the sleeve obscures full surface detail; a hidden crease or heavier wear could drop this to a 4. Sticker appears unpeeled and intact on its card backing, which is a positive for this issue.

Centering: the card backing shows roughly equal left/right margins (~50/50) and slightly tighter top margin vs bottom (~55/45 top-heavy), so centering itself is not a major concern. Surface shows moderate wear with visible scuffing and loss of gloss across the sticker image — the helmet area shows notable dulling and light scratching. Corners on the card stock (not the die-cut sticker edge) show visible rounding, most prominently at the lower-left and upper-left; the lower-right corner also shows a slight bend or ding. No creases are definitively visible from this angle, but the surface wear and corner rounding are consistent with a VG-EX (4) grade; if a light crease is hiding on the back or the corner damage is worse than it appears, this could slip to VG (3). The die-cut sticker edges appear intact with no chips or tears noted.